Loads are classified into resistive loads, inductive loads, and capacitive loads according to their impedance properties. Resistive load: A load with no phase difference between current and voltage is a resistive load, such as rice cookers, light bulbs, electric stoves, electric soldering irons, etc. Inductive load: The load when the current lags the voltage by a phase difference is an inductive l...
The large number of solar panels installed in the early 2000s is approaching the end of its life cycle, which poses a serious problem for the solar industry, and current solar panel disposal methods fall far short of environmental requirements. In theory, solar energy is more promising than ever. Solar cells are getting easier and cheaper to produce. But solar PVs have some less-talked-about quest...
First of all, the basis of the working principle of solar cells is the photovoltaic effect of the semiconductor PN junction. The so-called photovoltaic effect is an effect in which electromotive force and current are generated when the object is illuminated, the state of charge distribution in the object changes. When sunlight or other light hits the PN junction of the semiconductor, a voltage app...
With the gradual tightening of global energy supply and increasingly serious environmental pollution, independent and environment-friendly energy supply is becoming more and more important, and more and more households around the world choose to embrace this green energy transition with green electricity at home. However, in the face of the numerous and chaotic household energy storage products on...
The power generation of photovoltaic power plants is determined by many factors, among which the key factors are irradiance and ambient temperature. Hot summer is often accompanied by high temperature, not high irradiance. The temperature characteristics of solar modules are negative temperature coefficients, and the power generation performance of modules will decrease as the temperature increase...
Definition of state of charge (SOC) and depth of discharge (DOD) and their impact on lifespan of lifepo4 battery 1. State of Charge (SOC, State of Charge): In layman's terms, it is the ratio of the power stored in the battery (releasable capacity) to the maximum power that the battery can store. For example, if a battery with a maximum capacity of 100Ah(fully charged) is fully discharged to 5...
The power generation of a photovoltaic power station not only depends on the power generation performance of the photovoltaic power station itself, but also is closely related to the later operation and maintenance. Correct operation and maintenance can not only increase the power generation, but also greatly improve the service life of the equipment and power station. Let's discuss the main facto...
In the photovoltaic power station system, the grounding design is a crucial part of the electrical design, which is related to the safety of the power station equipment and personnel. Good grounding design can ensure that the power station is in a safe operating environment for a long time, reduce the frequency of faults, and improve the overall operating efficiency of the power station. Therefore...
To ask "What is the most feared problem of photovoltaic power generation?" Experienced people must know "the problem of shadow occlusion." 1. Small shadows, big hazards Because the position of the sun changes with the seasons and time, and the surrounding potential obstructions also change over time, anyone with experience in installing photovoltaic power plants understands that shadows are ...
In general, we call the process of converting DC power into AC power as inverter, the circuit that completes the inverter function is called inverter circuit, and the device that realizes the inverter process is called inverter equipment or inverter. Why are common grid-connected inverters only single-phase and three-phase? In fact, the main reason is the type of grid connected to the inverter. Fi...